NovoPress ACO403 BT Manuel D'utilisation page 25

8.1 Meaning of the LED display
LED display
All LEDs off.
Green LED (2) lights up.
Green LED (2) off
(pressing operation in
progress).
Green LED (2) flashes.
Blue LED (10) flashes.
Blue LED (10) lights up.
Red LED (3) flashes.
Red LED (3) lights up.
Red (3) and green (2)
LED flash alternately.
Red (3) and green LED
(2) flash slowly and
simultaneously.
Red (3) and green LED
(2) flash quickly and
simultaneously.
Status/cause
The device is switched off.
On standby.
Automatic press cycle is on,
device ends the pressing
operation automatically.
Insufficient battery charge.
The press device is ready
for connection.
The press device is
connected with the
NovoCheck app.
Device not within the
temperature range
Device fault.
Service interval reached.
Service interval reached. It
is possible to perform
another 500 pressing
operations before the
device is blocked
automatically.
The maximum number of
pressing operations before
maintenance is reached,
the device is blocked.
21
Measure
Briefly press the start button (1) (see
section 7.5).
Charge or replace battery.
The press device can be connected with
the NovoCheck app.
The device only works within a
temperature range of -10 to +50°C. If the
red LED is flashing, the device must be
moved into a warmer or colder area. The
device can be warmed to operating
temperature by means of dry runs.
If the device is too warm it must be cooled
down by means of a short break.
Press the start button (1). If this is
unsuccessful, the press device is
defective.
Send the device to a specialist workshop.
NOTE!
The pressing operation may not have
been completed; please check and repeat
if required.
Take the press device to be serviced
within the next 100 pressing operations.
Take the press device to the maintenance
service within the next 500 pressing
operations.
Take the press device to the maintenance
service.
ACO403 BT
EN