Additional Information; Remote Control Function Using A Parallel Remote Connector; Disabling Button Operations (Key Protect Function) (Pcm-R700 Only) - Sony PCM-R500 Mode D'emploi

Additional Information

Additional Information
Remote Control Function Using
a Parallel Remote Connector
You can operate the deck with a parallel remote control
that uses a switch box connected to the REMOTE 1
connector on the rear panel.
Using the REMOTE 1 connector
When operating the deck with a parallel remote
control, set the REMOTE switch on the front panel to
WIRED.
The pin numbers and pin assignments for the
REMOTE 1 connector on the rear panel are as follows:
DIN connector (8 pin)
7
3
5
Pin No MODE1
(playback)
Inputs
1 H-level constant
2 H-STOP/L-PLAY
3 L-STOP
4 L-PLAY
5 L-REW
6 L-FF
Status
7 H-STOP
output
8 H-PLAY
Case GND
Command inputs H: OPEN (off impedance: 30 kilohms or
more)
L: GND short (on impedance: 100 ohms
or less)
Status output H: approx 2V (I=15mA)
L: OPEN (High impedance)
Connection diagram (MODE 1)
1 2 3 4
OPEN
Command input
switch
EN
28
8
6
1
Case
4 y
2
MODE2
(recording)
L-level constant
L-STOP
L-START ID
WRITE
L-PLAY
L-PAUSE
L-REC
H-REC-PAUSE
H-REC
GND
Case
5 6 7 8
GND
Status output
display (LED)
Notes
• When using MODE 2, use pin number 1 for GND.
• By keeping the input to pin number 1 constant at either H-
level or L-level determines whether pin numbers 2 to 8 are
in MODE 1 (playback) or MODE 2 (recording).
• In MODE 1, pin number 2 may be used for fader-start
function.
• For pin numbers 2 to 6 pin, input to smaller numbers take
priority.
• Anti-chattering measures should be taken for the
command input switches.
• Status output (pin numbers 7 and 8) is specially provided
for driving a single LED. If more current is needed, use an
additional drive circuit or electric power supply.
• Do not switch input to pin number 1 (MODE 1 and MODE
2) while the deck is playing or recording. This may result
in mis-operation of the deck.
Disabling Button Operations
(Key Protect Function)
(PCM-R700 Only)
You can disable certain button operations so that the
buttons do not work during, for instance, recording.
KEY PROTECT
POWER
Ø ON ø OFF
REMOTE
WIRED OFF WIRELESS
KEY PROTECT
OFF ON AMS
PREVIOUS NEXT REW
= + 0
PHONE LEVEL
• START ID
INPUT OPEN/CLOSE STOP PLAY
AUTO REHEARSAL WRITE ERASE REPEAT LOCATE
MONITOR
6 p (
MIN MAX
SKIP ID
PHONES RENUMBER REHEARSAL WRITE ERASE FADER SKIP PLAY MARK
All of these buttons and dials
are disabled.
Set KEY PROTECT to ON.
INPUT
ANALOG DIGITAL
MODE
ANALOG INPUT
UNBALANCE BALANCE
COUNTER RESET
REC MODE
STANDARD LONG
MARGIN RESET
48k 44.1k
SBM
OFF ON
SHUTTLE DATA
FF REC MUTE MENU
REC LEVEL
) R r CH-1(L)
•
PAUSE REC
SET
0 10
P r
CH-2(R)
•
0 10
3-859-278-11(1)