Unpacking; Inserting Batteries Into The Remote; Rack Mounting - Sony PCM-R500 Mode D'emploi

Getting Started Getting Started

Unpacking

Check that you have received the following supplied
items:
• AC power cord (1)
• Remote commander (remote) RM-D757 (1)
• Size-AA (R6) batteries (2)
• Screws (M5×12) (4)
• Decorative washers (4)
• Operating instructions (1)

Inserting batteries into the remote

Insert two size-AA(R6) batteries, matching the + and –
on the batteries with the markings inside the battery
compartment.
Before using the remote
Set REMOTE on the front panel to WIRELESS.
WIRED
z
When to replace the batteries
With normal use, batteries should last for about 6
months. When the remote no longer operates the deck,
replace both batteries.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign matter into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
illumination as doing so may cause malfunction.
• When not using the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
4 EN
REMOTE
OFF WIRELESS

Rack Mounting

You can install your deck in a 19-inch 3U-size rack. Be
sure to disconnect the deck from the wall outlet before
you install it.
1
Remove the four feet from the deck.
2
Insert the deck into the rack and secure it with the
supplied decorative washers and screws (M5×12).
Note
Do not reattach the screws directly after removing the four
feet. Put the screws and the feet in a safe place for
reattachment in the future. Using longer or shorter screws
may damage the internal circuit board.
Screw (M3×10)
Rack
Screw (M5×12)
Decorative washer
3-859-278-12(1)