Writing Start Ids During Recording - Sony PCM-R500 Mode D'emploi

Writing Sub Codes
Writing Start IDs During
Recording
START ID AUTO
POWER
Ø ON ø OFF
REMOTE
WIRED OFF WIRELESS
PHONE LEVEL
• START ID
AUTO REHEARSAL WRITE ERASE
MIN MAX
SKIP ID
PHONES
RENUMBER REHEARSAL WRITE ERASE
CLEAR
Writing start IDs manually during recording
Press START ID WRITE.
"ID WRITE" appears in the display for a few seconds
and the start ID is written on the tape. "START ID"
flashes in the display during this time.
ID
Note
The interval between start IDs must be more than 18 seconds
(36 seconds in long-play mode). If the interval is less than 18
seconds (or 36 seconds), the deck may fail to detect the
second start ID while playing a tape.
Writing start IDs automatically during
recording
Press START ID AUTO repeatedly until "AUTO"
appears in the display.
For details on the condition for the automatic writing
of start IDs, see "Writing start IDs automatically during
recording" on page 7, and "Menu Operations" on
pages 24 and 25.
20 EN
START ID WRITE
INPUT
ANALOG DIGITAL
MODE
ANALOG INPUT
UNBALANCE BALANCE
COUNTER RESET
REC MODE
STANDARD LONG
MARGIN RESET
48k 44.1k
SBM
OFF ON
SHUTTLE DATA
AMS
PREVIOUS NEXT REW FF REC MUTE MENU
REC LEVEL
R CH-1(L)
= + 0 ) r
•
OPEN/CLOSE STOP PLAY PAUSE REC
REPEAT LOCATE
SET
0 10
6 p ( P r
CH-2(R)
•
SKIP PLAY MARK
0 10
DATA
OPEN/
CLOSE
COUNTER
REPEAT MODE RESET
1 2 3
4 5 6
Number buttons
7 8 9
CLEAR
0
W RI TE
START ID
Writing program numbers during recording
Program numbers occupy the same positions as the
start IDs and are determined by depending on the
following conditions:
When a program number is displayed
The next program number rises by one above when the next
start ID is written.
When no program number is displayed ("--" appears
instead)
Program numbers are not written even when start IDs are
written. To write program nunbers, rewind the tape to the
nearest start ID to display the program number, and then
locate the position where you want to start recording.
Specifying the first program number to be
assigned
1
Pause recording.
2
Press the number button(s) on the supplied
remote, or turn DATA to input the first program
number.
The number appears in the display.
To cancel the number, press the CLEAR button on
the supplied remote.
3
Start recording.
A start ID and the assigned program number are
written simultaneously.
Note
During automatic start ID writing the positioning of some
start IDs may be inaccurately or inappropriately positioned
away from the beginning of the track. If this happens, you
can reposition or erase the start IDs later (see "Accurate
positioning of sub codes" on pages 21and 22, and "Erasing
Sub Codes" on page 23).
3-859-278-11(1)