Reely Bulldog Notice D'emploi page 37

• As long as the vehicle is in operation you must always leave the transmitter switched on.
• When parking the vehicle, always switch off the vehicle's speed controller first and disconnect the drive
battery from the speed controller completely then. Now you may turn off the transmitter.
• If the batteries (or rechargeable batteries) in the transmitter are weak, their range decreases. Exchange
the batteries or rechargeable batteries for new ones.
• When the car's drive battery is weak, the car gets slower or no longer responds correctly to the transmit-
ter.
The drive battery in the vehicle is not only used for supplying the engine though the speed controller.
The speed controller also generates the voltage/current required for operating the receiver and the
steering servo.
For this, the speed controller has an integrated BEC ("Battery Eliminator Circuit"; electronic circuit for
direct voltage supply of the receiver without additional receiver battery).
If the voltage in the drive battery is too low, the voltage at the receiver may also drop, causing the vehicle
to no longer respond to the control commands at the transmitter.
In this case, stop driving at once (switch off speed controller, disconnect drive battery from vehicle,
switch off transmitter). Then replace the vehicle drive battery or recharge the drive battery.
Before recharging the rechargeable battery, let it cool off entirely.
• The motor and drive as well as speed controller and drive battery of the vehicle get hot during operation.
Wait at least 5 to 10 minutes before exchanging the rechargeable battery.
• Do not touch the motor, the speed controller or the rechargeable battery until they have cooled down.
Danger of burns!
37