Reely SKY Waco Notice D'emploi page 49

Aileron function (mode 1 and 2)
If the control lever for the aileron function (see figure 2, item 4) is moved to the left, the left wing's ailerons must break
out to the top and the right ailerons to the bottom. The rear rudder edge must be deflected or downwards or upwards
by approx. 3 - 5 mm. In flight, this presses the wing to the lower left and the model flies to the left with a little elevator
support.
If the control lever for the aileron function (see figure 2, item 4) is moved to the right, the left wing's ailerons must break
out to the bottom and the right ailerons to the top. The rear rudder edge must be deflected or downwards or upwards
by approx. 3 - 5 mm. In flight, this presses the wing to the lower right and the model flies to the right with a little elevator
support.
If the rudder does not deflect as described above, the DIP switch at the transmitter must be used to change
the running direction of the servos. For further information on this, refer to the following chapter „Setting the
DIP Switches".
Figure 17
Figure 18
49