Operation - Hach TU5200 Manuel D'utilisation De Base

Personal injury hazard. Do not look into the vial compartment when the instrument is connected to
power.
Refer to the illustrated steps that follow to connect power to the instrument and start the instrument.
When the language menu shows, select the language and then push OK. The self-check will start.
Note: To change the language after the initial startup, refer to

Operation

Configuration
Configure the instrument settings
1. Push two times, then push Setup.
2. Select an option.
Option
Location
Date & Time
Security
Sound Settings
12 English
Description
Sets the location name of the instrument. The location is saved with measurements to the
data log.
Sets the date format, the time format and the date and time. Enter the current date and
time. Date Format—Sets the date format. Options: dd-mmm-yyyy (default), yyyy-mm-dd,
dd-mm-yyyy or mm-dd-yyyy. Time Format—Sets the time format. Options: 12 or
24 hours (default).
Enables or disables password protection for the settings and tasks in the security list.
Security Password—Sets or changes the security (administrator) password
(10 characters maximum). Passwords are case sensitive. Security List—Sets the
security level for each setting and task in the security list.
• Off—All operators can change the setting and or do the task.
• One key—Only operators with a one-key or two-key security level can change the
setting or do the task. Refer to
• Two keys—Only operators with a two-key security level can change the setting or do
the task.
Note: The Security setting is not set to on until Close is pushed.
Enables or disables the sound settings for individual events. Sets the sound volume for
each event (1 to 10). To enable or disable all of the sound settings, select All and then
push Setup.
C A U T I O N
Change the language
Add operator IDs
on page 13.
on page 13.