Stihl TS 700 Notice D'emploi page 20

English
6
6
7
N
to relax the poly V-belt, loosen the
hexagon head screws (6)
N
Turn the tensioning nut (7)
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
N
Remove the hexagon bolts.
8
9
N
Pull the V-belt guard (8) off to the
front and remove the poly V-belt
from the front pulley
N
Remove the "bearing and guard" (9)
18
6
N
Fit the "bear with guard" (9) on the
outboard side of the cast arm - at
the same time, guide the poly v-belt
over the belt pulley
N
Slide on the V-belt guard
N
Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard.
N
Screw in the hexagon bolts, but do
not tighten them yet
2
1
N
Insert the longer banjo bolt (1)
through the connector (2) of the
water attachment
N
Note the connector position
N
Insert the square nut into the guide
in the guard and hold it in place
N
Fit the water attachment to the
adjusting lever with the longer banjo
bolt – screw in the banjo bolt
9
1
Continue as described in the chapter
"Tensioning the V-belt".
Version B (TS 700, TS 800)
N
Disassemble the abrasive wheel
(see "Fitting / replacing an abrasive
wheel")
1
A
N
Move the guard to the position
illustrated
N
pull out the plugs (arrows)
N
Mount the adjusting lever (1) in
position A
N
Press the plugs into the free holes
N
Undo the nuts (2)
N
Remove the washer (3)
TS 700, TS 800