Fitting / Replacing An Abrasive Wheel - Stihl TS 700 Notice D'emploi

English
N
Turn the tensioning nut clockwise
approx. 1/8 turn – the tensioning nut
will be engaged by the spring
N
Continue turning approx. 1/8 turn –
up to the stop
Do not turn the combination
wrench further by force.
The ribbed V-belt is automatically
tensioned by the force of the spring in
this position.
N
Remove the combination wrench
from the tensioning nut
N
Tighten hexagon head screws (1)
on the V-belt guard
Retensioning the poly ribbed V-belt
The poly V-belt is retensioned without
the aid of the tensioning nut.
N
Unscrew the three hexagon bolts on
the V-belt guard
The poly V-belt is automatically
tensioned by the force of the spring.
N
Retighten the hexagon bolts.
20
Fitting / replacing an
abrasive wheel
The engine must be switched off for
fitting or replacement – set Master
Control lever to STOP or 0.
Blocking the shaft
N
Slide the locking pin (1) through the
bore in the V-belt guard
N
Turn the shaft with the combination
wrench until the locking pin (1)
engages in a bore behind the guard
Removing a cutting wheel
N
Use the combination wrench to
loosen and remove the hexagon
head screw (2)
N
Remove the front thrust washer (3)
from the shaft together with the
cutting wheel
TS 700, TS 800