Stihl TS 700 Notice D'emploi page 19

Version A (TS 700)
2
Version B (TS 700, TS 800)
Distinguishing features
– Deflector shape (1)
– Adjusting lever shape (2)
Outboard mounting
Version A (TS 700)
N
Disassemble the abrasive wheel
(see "Fitting / replacing an abrasive
wheel")
TS 700, TS 800
2
N
Unscrew the banjo bolt (1)
N
Remove the square nut from the
guide from the inboard side of the
guard
N
Detach water attachment (2) from
adjusting lever
4
3
N
Turn the guard in the direction of the
arrow until the adjusting lever points
forwards
N
Undo the banjo bolt (3) and remove
the bolt and washer
N
Remove the square nut from the
guide from the inboard side of the
guard
N
Remove screw (4)
N
Turn the adjusting lever upwards
and remove
1
N
Move the adjusting lever (5) to
position A
N
Screw in the bolt (4) and tighten up
N
Insert the square nut into the guide
in the guard and hold it in place
N
Screw the shorter banjo bolt (3) and
washer on to the adjusting lever and
tighten up
N
Turn the guard in the direction of the
arrow until the adjusting lever points
forwards
English
4
A
3
5
17