Checking The Spark Plug - Stihl TS 700 Notice D'emploi

English
N
If the screen is damaged or heavily
carbonized, fit a new one
N
Refit the spark arresting screen in
reverse order of steps
Spark arresting screen fastened with
screw
2
1
N
Remove screw (1)
N
Pull out spark arresting screen (2)
with a suitable tool
N
Clean the soiled spark arresting
screen
N
If the screen is damaged or heavily
carbonized, fit a new one
N
Refit the spark arresting screen in
reverse order of steps
28

Checking the Spark Plug

If the engine is down on power, difficult
to start or runs poorly at idle speed, first
check the spark plug.
N
Removing the spark plug
N
Clean dirty spark plug.
N
Check electrode gap (A) and
readjust if necessary – see
"Specifications".
N
Rectify the problems which have
caused fouling of the spark plug.
Possible causes are:
– Too much oil in fuel mix.
– Dirty air filter.
– Unfavorable running conditions.
N
Fit a new spark plug after about 100
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
To reduce the risk of arcing and fire
If the spark plug comes with a
detachable adapter nut:
N
Screw the adapter nut (1) onto the
thread and tighten it down firmly.
TS 700, TS 800
1