Clock Mode Setting; Clock Input Connector Setting; D/A Converter Setting - Esoteric P-02X Mode D'emploi

Clock mode setting

CLK>***
By default, the setting is OFF.
OFF
The built-in crystal oscillator operates as the master clock.
IN
The built-in crystal oscillator is synchronized to an external clock.
MCK22M
A 22.5792MHz external signal is input and used as the master
clock.

Clock input connector setting

CLKin>***
Change the input connector used to receive a clock sync signal.
By default, the setting is CLK.
CLK
The signal input through the CLOCK IN connector (75Ω input
impedance) is used.
10M
The signal input through the 10MHz IN connector (50Ω input
impedance) is used.

D/A converter setting

DAC>***
Set the type of connected D/A converter. Depending on the type set,
SACD playback output might not be possible. This also sets the type
of copyright protection encryption.
By default, the setting is ESL3.
ESL3
Use this setting when connected to an ESOTERIC Grandioso D1,
D-02 or D-02X.
When ESLINK or DUAL connection is selected, CD playback is out-
put using the unique ESOTERIC ESL3 48-bit format. SACD playback
is output using the ESL2 format.
ESL2
Use this setting when connected to an ESOTERIC D-03, D-05, D-07
or D-07X.
During CD playback, the signal is output in 24-bit format. SACD
playback is output using the ESL2 format.
ESL1
Use this setting when connected to an ESOTERIC D-01.
During CD playback, the signal is output in 24-bit format. SACD
playback is output using the ESL1 format.
OTHER
Use this setting when connected to any D/A converter other than
the ones above.
SACD DSD audio signals are not output.
27