Beem Tea Time 12846 Mode D'emploi page 31

EN
Operation
Operating Buttons
On / Off Button
The device can be switched on and off using the On / Off button (11). The control lamp in
the button lights up as soon as the device is switched on.
Keep Warm Button
The keep-warm function can be switched on using the keep warm button (12). The
control lamp in the button lights up as soon as the function has been switched on.
Temperature Buttons
The temperature buttons (13 – 16) are used to set the temperature of the water. The
following settings can be selected:
70°C
ideal for very delicate types of tea
80°C ideal for white or green tea
90°C ideal for green tea
100°C ideal for black tea, herbal tea / boiling water
Removing / Attaching the Lid
1. Hold the lid (1) by the lid handle (2) (Picture A) and pull it upwards. At the same time,
the tea strainer (6) and tea strainer holder (7) is pulled out of the kettle.
If the device was in operation, use potholders or similar gloves as the lid handle may
be hot and hot water may drip from the tea strainer. Always allow the device to cool
down before using it again.
2. To close the device, place the lid back on the kettle. When you do this, make sure that
it fi ts correctly and is heard to engage.
Filling the Kettle
Only ever fi ll the kettle (3) with fresh, clear tap water. Do not pour in any other liquids.
1. Open the lid (1) (see the "Operation" chapter | "Removing / Attaching the Lid").
2. Pour the desired quantity of water (maximum 1.7 litres) into the kettle. Note the MIN (5)
and MAX marking (8).
3. Close the lid (see the "Operation" chapter | "Removing / Attaching the Lid").
09100_DE-EN-FR-NL_A5_V1.indb 28 09100_DE-EN-FR-NL_A5_V1.indb 28
28
04.10.2017 11:49:56 04.10.2017 11:49:56