Assembly Of Spray Guard And Cover Accessories - IKA HB 10 Mode D'emploi

 Start the 'Heating' function with the ON/OFF key (B).
 An animated heating symbol appears on the LC display, see
fi g. 7.
 The heating bath is heated up to the set temperature.
 The target and actual temperature referred to the medium are
shown on the LC display, see fi g. 7.
Select tempering medium
 If a target value > 90° C is set, the PID controller is adapted
specially for oil.
 The symbol OIL appears on the LC display, see fi g. 8.
 If the target value is reset to 20 °C the PID controller is adjus-
ted again specially to water.
 The OIL symbol will disappear from the LCD display, see e.g.
fi g. 7.
Key lock button
The operating settings can be locked by pressing (hold for 2
seconds) the key lock button (E)
vertent changes during operation. The red function LED lights
up when this function is activated. Press the key lock button (E)
again (hold for 2 seconds) to unlock the operating set-
tings. The red function LED is extinguished.
Assembly spray guard HB 10.1
 Assemble the spray guard as illustrated.
- Place the bracket of the spray guard on the front edge of the heating bath.
- Attach the spray guard by tightening the screws using a screwdriver.
Assembly Cover HB 10.2
 Assemble spray guard and cover as illustrated.
- Push the angled sheet on the back part of the cover into the guide rails at
the rear of the heating bath.
- Screw the back and front part of the cover to the spray guard.
Heruntergeladen von manualslib.de
,preventing any inad-

Assembly of spray guard and cover accessories

Handbücher-Suchmachiene
Interface
Data transfer via IR interface
IR
The heating bath transfers data via IR interfaces. These are loca-
ted on the left display side of the heating bath or on the right
side of the drive unit. Do not place any objects between the two
operating units as otherwise the data transfer may be interrup-
ted (fi g. 12)!
Remote Mode
Using the laboratory device software "labworldsoft" and the ro-
taty evaporator RV 10 digital/ control the device can be operated
in "Remote" mode. In this mode, the device can no longer be
hand-operated.
 LCD display see fi g. 9
Note: Please note the system requirements as well as the ope-
rating instructions and help section included with the software.
Fig. 12
Fig. 13
Fig. 14
Fig. 15
14