Error Message; Accessories - IKA HB 10 Mode D'emploi

Masquer les pouces Voir aussi pour HB 10:

Mode d'emploi (48 pages)

Mode d'emploi (60 pages)

Table Des Matières

Table des Matières

Les langues disponibles

Any malfunctions during operation will be identiﬁ ed by an error message on the display (D), see ﬁ g. 5.

Proceed as follows in such cases:

 Switch off device using the main switch (B)

 Carry out corrective measures

 Restart device

Error message Cause

E 2

E 3

E 9

E 21

E 23

E 24

E 25

E 26

E 28

E 29

E 30

E 32

If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:

- contact the IKA

- send the device for repair, including a short description of the fault.

HB 10.1 Spray guard

Heruntergeladen von

manualslib.de

- In remote operation (PC), no communication

between RV 10 and HB 10

- IR connection to RV 10 disconnected

- Temperature inside the device is too high

- Fault in storing the safety circuit set

temperatures

- Memory chip (EPROM) defective

- Safety relay does not open

- Adjustable safety circuit defective

- Set safety temperature exceeded

- The heater control circuit switch (TRIAC) is

faulty. The heater or the supply line is

disconnected.

- Dry running

- Breakage of the controller sensor

- Short-circuit in the safety sensor

- Short-circuit in the controller sensor

- Error in calibration

service department,

Handbücher-Suchmachiene

Error message

Effect

Correction

Heating off

- Switch off the device

- Clean the IR interface or

- Switch on the device

Heating off

- Switch off the device

- Let the device cool down

- Switch on the device

Heating off

- Switch off the device

- Let the device cool down

- Switch on the device

Heating off