Scheppach Bestcombi 7.0 Traduction Du Manuel D'origine page 24

Failure
Machine vibrates
Unclean cuts / wood burns
Fast wear and tear fo tool
Motor heats up (one can no
longer touch it with bare hands,
it switches off constantly)
Machine stops
The wood is lifted high by the
rear part of the saw blade
Height adjustment of the spindle
is stiff
Machine vibrates
Unclean cuts / wood burns
D GB
Fast wear and tear of tool
Motor heats up (one can no
longer touch it with bare hands,
it switches off constantly)
Machine stops
Height adjustment of the spindle
is stiff
Motor does not stop
Machine tables are too rigid to
actuate
Working speed is unusally slow
Machine vibrates
Formation of recess or
workpiece is not straight after
planing
Possible cause
Clamping lever for height adjustment is not screwed tightly
Tool is not screwed tightly
Tool is blunt
Tool is not installed correctly
Tool is sharpened incorrectly
Covered wood (cement, sand, nails)
Different causes possible
Feed is too fast
Tool is blunt
Longitudinal stop is not parallel
Splitting wedge not in alignment or sewing is too weak
Threaded rod, toothed wheels, slide rails are polluted
Clamping lever is not loosened
Clamping lever for height adjustment is not screwed tightly
Tool is not screwed tightly
Tool is blunt
Tool is not installed correctly
Tool is sharpened incorrectly
Covered wood (cement, sand, nails)
Different causes possible
Feed is too fast
Tool is blunt
Threaded rod, toothed wheels, slide rails are polluted
Clamping lever is not loosened
Incorrect position of the control button
No power
Power failure
Position of vacuum suction sensor is incorrect
Threaded rod, toothed wheels, slide rails are polluted
Tool is blunt
Cut deep to big
Polluted drive rollers
Table is not clean or is damaged
Belt slips
Blunt or poorly belt tool
Differences in the dimensions of the tool
Uneven base
Tool is set higher than the transporting table
Improper laying or poor support of workpiece on the machine
Error search plan
Remedy
Saw
Tighten clamping lever
Tighten tool
Use sharp tools only
Check correct installation of the tool
Have the tool re-sharpened correctly / install new tool
Use clean wood only
Get it checked by an electrician
Reduce feed
Use sharp tools only
Readjust longitudinal stop
Readjust splitting wedge
Clean and lubricate components
Check and loosen clamping lever
Milling machine
Tighten clamping lever
Tighten tool
Use sharp tools only
Check correct installation of the tool
Have the tool re-sharpened correctly / install new tool
Use clean wood only
Get it checked by an electrician
Reduce feed
Use sharp tools only
Clean and lubricate components
Check and loosen clamping lever
Jointer and planer
Check the position of the control buttons
Connect machine to the mains power supply
Get it checked by an electrician
Check position, readjust if necessary
Re-lubricate components
Use sharp tools only
Reduce cutting thickness
Clean working rollers
Clean table
Re-stratch belt
Install new tool / re-adjust
Mark tools in sets
Adjust table legs
Set tool correctly
Place tool carefully
24