Air Connection; First Use - Airpress H Manuel D'instructions

skilled personnel for electric connections.
Before first use first read chapters 3.2 and 4.0.

3.2 AIR CONNECTION

Best use for connection of the compressor to an air circuit a flexible hose, to isolate
vibrations from the machine. The diameter of the hose must meet the connection of
the ball cock. The quick coupling supplied has to be mounted with tape on the outlet
of the reducing valve (on cock (h)).

4.0 FIRST USE

1. Check if the instructions mentioned above have been executed.
2. Check the oil level of the compressor (see chapter 6.0 point 3.). Possibly oil has
been lost during transport. Fill if necessary with AIRPRESS compressor oil.
Avoid the use of extension cables. If you use them, unroll them completely and use
cables of sufficient capacity.
Table for extension cables:
For 230 volt:
0 - 10 meter: 3 x 1 1/2 mm
10 - 25 meter: 3 x 2 1/2 mm
Compressor with direct drive:
 Switch on the compressor by means of the pressure switch (a).
 The compressor will now operate, unless the air receiver is still under pressure
(k).
 Switch the machine, during operation, exclusively off by means of the button on
the automatic pressure switch (a); the pressure circuit will be vented and the
compressor can start again uncharged.
H 85 without air tank and with 0/1 switch on junction box on the motor.
Compressor with V-belt drive:
 Check tension on the V-belt. At the right tension the V-belt (u) can easily be
turned by hand approximately 45 degrees. If necessary, improve tension. See
chapter 6.0 point 5.
 Let the compressor run for a short while so you can check if the turning direction
is correct (see arrow on belt
motor runs in the wrong direction, switch two phases of the electric plug.
Disconnect electricity!
 For daily operation of the compressor, see chapter 5.0.
For 400 volt:
2
0 - 25 meter: 4 x 1 1/2 mm
2
25 - 50 meter: 4 x 2 1/2 mm
protector (r)) (only valid for model 400 V). If the
25
2
2