Startup - Hach TitraLab AT Série Manuel D'utilisation De Base

Startup

Chemical exposure hazard. Obey laboratory safety procedures and wear all of the personal protective
equipment appropriate to the chemicals that are handled. Refer to the current safety data sheets
(MSDS/SDS) for safety protocols.
Personal injury hazard. Never use the instrument without the syringe cover installed.
Configure the instrument
1. From the main menu, select
2. Select an option, then push Select.
Option
Applications
Operators
Date + Time
Brightness
Sounds
Language
Info
Restore Defaults Sets the instrument to the default configuration.
Options
3. Push Back.
Install the applications
Use the supplied USB key to install the applications. The instrument can install a maximum of five
applications for each syringe installed. For two syringes, the installed applications shown on the top
line of the display refer to syringe one and the installed applications shown on the second line refer to
syringe two. If any errors occur during installation, refer to
1. Push Home to go to the main menu.
2. Connect the USB key to the USB port on the side of the instrument. The applications on the USB
key show on the display.
3. Push the arrow keys to highlight and select an application to install. Push the left or right arrow
key to select it. Do this step again to select additional applications to install.
4. Push Import to install the selected applications.
5. Push OK to complete the installation. The installed applications show on the main menu.
Note: To install more applications, push Home to go to the main menu, then remove the USB key and
reconnect it.
16 English
Settings.
Description
Exports, changes, removes and makes copies of application data. Make sure that the
duplication function does not make more than five applications for each syringe installed.
Adds, changes and removes operators.
Sets the instrument date and time.
Sets the brightness of the display.
Sets the sound options.
Sets the language.
Shows information about the instrument and the attached hardware.
Sets the application parameters view to expert mode, which lets the user customize the
standard measurement applications. When the instrument is set to off, sets the syringe to
empty into the titrant bottle. Changes the temperature display from Celsius to Fahrenheit.
If a printer is connected, prints the measurement and derivative curves.
C A U T I O N
C A U T I O N
Troubleshooting on page 22.