Hach TitraLab AT Série Manuel D'utilisation De Base page 14

Install the titrant and the reagent
Chemical exposure hazard. Obey laboratory safety procedures and wear all of the personal protective
equipment appropriate to the chemicals that are handled. Refer to the current safety data sheets
(MSDS/SDS) for safety protocols.
Loosen the tube connector on the bottle cap.
Fill a desiccant cartridge with an applicable desiccant. Put the desiccant cartridge into the adapter on
the bottle cap.
Push the inlet tube through the connector. Make sure that the end of the tube is at the bottom of the
bottle. Tighten the connector on the bottle cap.
Refer to the "Application Note" on the USB applications key to identify the correct pump to connect to
the reagent bottle. Refer to the illustrated steps that follow.
14 English
C A U T I O N