Hach TitraLab AT1000 Série Manuel D'utilisation Simplifié page 25

7.5 Purge
Use this procedure to remove air bubbles from the system. Refer to
measurement on page 20 for instructions.
Section 8 Maintenance
Multiple hazards. Only qualified personnel must conduct the tasks described in this
section of the document.
Do not disassemble the instrument for maintenance. If the internal components must be cleaned or
repaired, contact the manufacturer.
8.1 Clean the instrument
Never use flammable or corrosive solvents to clean any part of the instrument. Use of these
solvents can degrade the environmental protection of the instrument and may void the warranty.
Clean the exterior surface with a moist cloth or with a mixture of water and mild detergent. Dry with a
soft cloth.
8.2 Clean the sensor
Refer to the documentation delivered with the sensor.
8.3 Maintenance menu
Refer to the Full User Manual, which is available as a download from our website.
C A U T I O N
N O T I C E
N O T I C E
Prepare the instrument for
English 25