Scheppach MFH3300-4P Traduction Du Manuel D'origine page 34

• Wash the filter element in warm soap water, rinse and
allow drying naturally.
Important: Never clean the air filter with petrol or
inflammable solvents.
In order not to shorten the service life of the engine, a
damaged air filter must be replaced at once.
m Warning!
Never run the engine without the air filter element
installed.
Care of the guide rail
Turn the rail around every time you have the chain
sharpened or replaced. This will avoid a one-sided wear
of the rail, especially at the top and bottom.
Regularly clean
1 = the opening for the oil supply
2 = the oil passage
3 = the raceway groove of the rai
Servicing and sharpening of saw chain
The correct sharpened chain
Working effectively with the chainsaw is only possible if
the chain is in good condition and
sharp. This also reduces the risk of kickback. The chain
can be re-sharpened by any dealer. Do not attempt
to sharpen the chain yourself unless you have the
necessary special tools and experience. A properly
sharpened chain goes way through the wood and it
requires very little pressure. Do not work with a dull or
damaged chain. It increases physical exertion, increase
the vibrations and leads to unsatisfactory results and
higher wear.
• Clean the chain.
• Check it.
• Replace damaged or worn parts with matching spare
parts they are in the shape and size of the original
parts as necessary.
• Sharpening a chain should be performed only by
experienced users!
Notice. Below the angle and dimensions If the chain
is not properly sharpened or the depth is too small,
there is a higher risk of reversion effects and resulting
injuries! The chain cannot be fixed on the guide rail. It
is therefore best to remove the chain from the rail and
then sharpen.
• Select the appropriate tools for the chain pitch
sharpening tool. See "Specifications" for the allowed
chain pitches.
The chain pitch (for example 3/8 ") is highlighted in the
depth of each blade.
Use only special files for chainsaws! Other files have the
wrong shape and the wrong cut.
34 GB
Select the file according to the diameter of your chain
pitch. Make sure to observe the following angle when
sharpening the chain diameter.
A = filing angle
B = the angle of the side plate
The angle must also be maintained for all knives.
For irregular angles, the chain is run irregularly, wear
quickly and break down prematurely.
2
Since these requirements can only be met with sufficient
and regular exercise:
• A File Holder must be used when sharpening the saw
• Hold the file horizontally (at a right angle to the guide
1
3
• File down. The knife is always from the inside to the
• The file sharpens only in forward motion. Lift it off in
• Do not touch the dynamic links with the file.
• Turn the file regularly continue to avoid a onesided
• Remove to remove a piece of hard wood, bones raw
All knives must have the same length, otherwise they
will also vary. As a result, the chain is irregular and it
increases the risk of going broke.
Lubricate angle transmission
Lubricate with lithium-based grease. Remove the screw
and put in the grease, turning the shaft manually until
grease emerges, then replace the screw.
Storing the unit
After cutting, clean the unit thoroughly. Store the unit in a
dry room allow the motor to cool down beforehand.
Important hint in case of sending the equipment to a
service station:
Due to security reasons please see to it that the
equipment is sent back free of oil and gas!
Ordering replacement parts
Please quote the following data when ordering
replacement
parts:
• Type of machine
• Article number of the machine
chain by hand. The correct filing angle marked on it.
rail) and file according to the angle mark on the file
holder. Support the file holder on the top plate and
depth gauge.
outside
the backward motion.
wear.
edges.