Product Description And Specifications; Intended Use; Product Features; Technical Data - Bosch GCD 12 JL Professional Notice Originale

Symbols and their meaning
Wear hearing protection. Exposure to
noise can cause hearing loss.
Wear a dust mask.
Take note of the dimensions of the saw
blade. The hole diameter must fit the tool
spindle without play. If it is necessary to
use reducers, ensure that the dimensions
of the reducer are suitable for the base
blade thickness and the saw blade hole
diameter, as well as the tool spindle dia-
meter. Wherever possible, use the redu-
cers provided with the saw blade.
The saw blade diameter must match the
information specified on the symbol.
Product description and
specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.

Intended use

The power tool is intended for stationary use with saw
blades to make straight cuts with and against the grain, as
well as mitre angles up to 45° in metal materials without the
use of water.

Product features

The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Locking lever
(2) Laser protection cap
(3) Spindle lock
(4) Retracting blade guard
(5) Chip box
(6) Angle guide
(7) Locking spindle
(8) Quick release
(9) Spindle handle
(10) Clamping lever of the saw table extension
(11) Saw table extension
Bosch Power Tools
(12) Hex key (6 mm)/cross-headed screwdriver
(13) Clamping handle for mounting the angle guide
(14) Transport safety lock
(15) Protective guard
(16) Handle
(17) On/off switch
(18) Laser warning label
(19) On/off switch for laser (cutting line indication)
(20) Transport handle
(21) Cover plate
(22) Bracket
(23) Mounting holes
(24) Chip drawer
(25) Saw table
(26) Lower fastening screw (cover plate/retracting
blade guard)
(27) Upper fastening screw (cover plate/retracting
blade guard)
(28) Guide bolt
(29) Hex socket screw for mounting the saw blade
(30) Clamping flange
(31) Saw blade
(32) Inner clamping flange
(33) Angle indicator
(34) Scale for mitre angles
(35) Set screw for laser positioning (parallelism)
(36) Screw for angle indicator
(37) Laser beam output

Technical data

Metal cut-off saw
Article number
Rated power input
No-load speed
Laser type
Laser class
Laser line divergence
Weight according to EPTA-
Procedure 01:2014
Protection class
Dimensions of suitable saw
blades
Max. saw blade diameter
Base blade thickness
English | 13
GCD 12 JL
3 601 M28 0..
W 2000
-1
min 1600
nm 650
mW < 0.39
1M
mrad (full 1.0
angle)
kg 20
/ II
mm 305
mm 1.8 − 2.5
1 609 92A 5WZ | (10.11.2020)