Storage; Disposal And Recycling; Troubleshooting - Scheppach EMP-33 Traduction Des Instructions D'origine

11. Storage

Storage
• Disconnect the lawn mower from the electricity sup-
ply when it is not being used.
• Oil the blades to prevent rust
• Store the device in a dry place beyond the reach of
children.
• When the device is not being used, store it so it can-
not be started by unauthorised persons.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.

13. Troubleshooting

The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equip-
ment fails to work properly. If the problem still persists after working through the list, please contact your nearest ser-
vice workshop.
Before working on the device, disconnect the mains cable from the socket.
Fault Possible cause
• no power supply
Lawn mower does not
operate
• power supply socket faulty
• extension cord damaged
• grass too high
• On/Off switch faulty
Lawn mower operates • extension cord damaged
intermittently
• internal wiring defective
Lawn mower leaves • cutting height cut too low
ragged finish or motor
• cutting blade blunt
• underside of lawn mower badly clogged
labours
• cutting height not uniform
Cutting blade not • cutting blade obstructed
rotating • blade nut/bolt loose
Lawn mower vibrates • cutting blade damaged
abnormally
• blade nut/bolt loose
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Remedy
• check power supply (power cable,circuit
breakers, fuses)
• use another socket
• replace extension cord
• increase cutting height as required
• Contact the service centre
• replace extension cord
• contact dealer
• increase cutting height
• replace cutting blade
• clean lawn mower as described
• set 4 wheels at same cutting height
• clear obstruction
• tighten blade nut/bolt
• replace cutting blade
• tighten blade nut/bolt
23