Scheppach MTP750 Traduction Des Instructions D'origine page 47

m WARNING!
Health hazard!
Inhalation of petrol/lubricating oil vapours and exhaust
gases can cause serious damage to health, uncon-
sciousness and in extreme cases death.
- Do not breathe petrol/lubricating oil vapours and
exhaust gases.
- Empty out fuel only outdoors.
1. Hold a collection bucket under the hose of the pet-
rol extraction pump (not included in the scope of
delivery).
2. Unscrew and remove the fuel tank filler cap.
3. Push the hose of the petrol extraction pump into
the fuel tank (21) and pump out the petrol com-
pletely using the petrol extraction pump.
4. Retighten the fuel tank filler cap.
13.6 Adjusting the clutch
The clutch play changes with the wear of the clutch.
To enable proper operation, the clutch cable must be
adjusted.
1. Set the clutch lever (1) to the original position using
the adjuster.
2. To do this, tighten the counternut with a 10 mm
open-ended spanneruntil the clutch engages
properly again.
13.7 V-belt tension and V-belt replacement
To do this, contact a specialist workshop.
Please provide the following information in the
event of any enquiries:
• Product data - type plate
• Motor data - type plate
Important note in the case of repairs:
When returning the product for repair, for safety rea-
sons, ensure that it is free of oil and fuel when it is sent
to the service centre.
13.8 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Type of product
• Article number of the product
Spare parts / accessories
Petrol suction pump
Potato harvester
Plough
Iron wheel
Adjustable furrow attachment
13.9 Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
Wearing parts*: Spark plugs, blades, air filter, all oper-
ating materials
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
14. Storage
m DANGER!
Risk of fire and explosion!
Storing the product near potential sources of ignition
can result in a fire or an explosion. This can lead to
severe burns or death.
- Eliminate possible sources of ignition, such as fur-
naces, hot water boilers with gas, gas dryers, etc.
NOTE!
Risk of damage!
If the product is not stored properly, the engine can be
damaged.
- Store the product protected against dirt, dust and
moisture.
14.1 Storage during extended breaks in operation:
If the petrol motor hoe will not be used for a period of
more than 30 days, the following measures must be
taken to prepare your petrol motor hoe for storage.
1. Empty the fuel tank completely (see section 14.4).
Stored petrol containing ethanol or MTBE be-
comes stale within 30 days. Stale petrol has a high
rubber content and can thus clog the carburettor
and restrict the petrol supply.
2. Start the engine and let it run until it stops. This
ensures that no petrol remains in the carburettor.
This prevents deposits from forming in the carbu-
rettor and potentially damaging the engine.
3. Drain the engine oil from the engine while it is still
warm. Fill with new oil (see section 14.1.).
Article no.: 4. Allow the engine to cool down. Remove the spark
7907600001 plug and fill 30 ml of good quality engine oil into the
7912301702 cylinder. Pull the starter rope (22) slowly to distrib-
7912301703 ute the oil. Replace the spark plug.
www.scheppach.com
7912301704
7912301705
GB | 47