Network Configuration Request Frame; Frame For Adding An Offset To Pulse Counters; Specific Register Value Request Frame - ADEUNIS sigfox RC1 Pulse Guide Utilisateur

sigfox RC1 Pulse - Guide utilisateur / User guide version V2.0.2

4.2.2 Network configuration request frame

This frame allows to inform the product via the network that it must resend the network configuration uplink frame (0x20).
0 1
Code PAYLOAD
0x02 X

4.2.3 Frame for adding an offset to pulse counters

These frames (0x03 and 0x04) allows to add an offset to the counter value on each channel.
0 1 to 4
Code
0x03 Offset - A-channel
0x03 0x00000015
Its size is of 5 bytes.
Description of the frame :
• Bytes 1 to 4: Offset - channel A : numbers of pulses to add to current index of the meter (channel A) (unsigned 32-bits, MSB first).
In the example in grey this gives:
• Bytes 1 to 4 =0x00000015 so 21 pulses to add to channel A counter
0
Code
0x04 Offset - B-channel
0x04 0x00000050
Its size is of 5 bytes.
Description of the frame :
• Bytes 1 to 4: Offset - channel B : numbers of pulses to add to current index of the meter (channel B) (unsigned 32-bits, MSB first).
In the example in grey this gives:
• Bytes 1 to 4 = 0x00000050 so 80 pulses to add to channel B counter

4.2.4 Specific register value request frame

This frame (0x40) allows to inform the product via the network that it must send the values of specific registers.
Frame 0x40 :
0 1
Code PAYLOAD
0x40 CONF ID1
Description of the frame:
• Bytes 1 to N : CONF IDX (8bits): index of the register to be sent.
The corresponding register is 300 + CONF IDX value.
For example, if CONF ID1 = 20, the product will send back the value of register number 320.
The associated uplink frame has the code 0x31 (see paragraph 4.1.5).
2 3
X X
1 to 4
2 3
CONF ID2 CONF ID3
4 5
X X
4 5
X X
6 7
X X
EN
... 7
X CONF IDn
Page 91 of 104