Mounting The Counters On The Screw Terminals - ADEUNIS sigfox RC1 Pulse Guide Utilisateur

sigfox RC1 Pulse - Guide utilisateur / User guide version V2.0.2
5.3.

Mounting the counters on the screw terminals

Once the nut and packing seal are installed, the strands of the meter cable can be connected to the screw terminals of the product.
Below is the identification of each terminal block:
Note: Up to 2 meters of the same type can be used in parallel.
Below is a description of the terminal blocks:
EN
Meter with 2-wire output
In this configuration, it is necessary to deactivate the input TAMPER of A-channel (register 320 bit 3 = 0) and preferably deactivate B-channel
(register 320 bit 4=0) which is not no used.
GND
IMPULSE_2 / Black
TAMPER_2 / Yellow
GND / Brown
IMPULSE_1 / White
TAMPER_1 / Green
GROUND / GND
IMPULSE / BF
GND / Brown
IMPULSE_1 / White
Page 94 of 104