Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SIGFOX SENSORS - Mode d'emploi / User guide version V2.1.1
2. PREPARATION AND CONFIGURATION
2.1. Disassembling the casing
The product is supplied disassembled such that the lower electronic part can be accessed. This part is where the meter or meters are connected
to the screw terminals and where the configuration switches can be accessed.
Once connection of the meters has been finalised and configuration carried out, the case may be closed.
Please note: once the case has been closed, opening it is no longer possible without the risk of losing the IP67 protection index guarantee.
2.2.
Fitting the packing gland seal
Before connecting your sensor's cable strands to the product's screw terminals, you must insert the packing gland's nut and the seal appropriate
for your configuration.
Three types of seals are supplied with the LoRaWAN Sensors unit: For a cable with a diameter of 5 mm, for a cable with a diameter of 3 mm,
and for two cables with diameters of 2.2 mm.
Assembly procedure:
1- Your sensor and its
2 - Pass the cable
analog interface.
through the compres-
sion gland nut.
2.3. Mounting the sensor on the screw terminals
Once the nut and the compression gland seal have been installed, the meter cables can be connected to the SIGFOX SENSORS'S screw terminal.
Please find details of each terminal below:
Sensor 1
Sensor 2
All manuals and user guides at all-guides.com
Seal for 1 x 5 mm cable
Seal for 1 x 3 mm cable
3 - Pass the cable
through the compres-
sion gland seal
GND_1
GND_2
TOR_1
TOR_2
Seal for 2 x 2.2 mm cables
4 - Pass the cable
5 - Install the O-ring
through the SIGFOX
seal on the case plate.
SENSORS'S case plate.
Dry Contact sensor(s) direct assembly
GB
6 - Connect the ends
of the meter cable to
the screw terminals.
Page
33
of 45
Publicité
Table des Matières
