SIGFOX SENSORS - Mode d'emploi / User guide version V2.1.1
•
Clip the electronic board to the case plate. Make sure the clip is fully engaged in the lug in the board.
•
Insert the upper part of the case. Inside this part are the board's guide rails for the board. Make sure the board is properly ositioned within
these guides.
•
Once the board is in position, lower the upper cover and lock it onto the case plate. Strong pressure will enable parts to be clipped toge-
ther and will enable protection level IP67 to be ensured.
Locking clips on the
upper casing
All manuals and user guides at all-guides.com
Lug
Clip
GB
Page
37
of 45