Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SIGFOX SENSORS - Mode d'emploi / User guide version V1.3
1.4.5 Sensors compatibility
Examples of sensors tested by Adeunis RF (non-exhaustive list)
Type
4-20mA
4-20mA
0-10V
0-10V
Dry Contact
2. Preparation and configuration
2.1. Dismantling the case
The product is supplied disassembled such that the lower electronic part can be accessed. This part is where the meter or meters are connected
to the screw terminals and where the configuration switches can be accessed.
Once connection of the meters has been finalised and configuration carried out, the case may be closed.
Please note: once the case has been closed, opening it is no longer possible without the risk of losing the IP67 protection index guarantee.
2.2.
Installation of the compression seal
Before connecting your meter cables to the product's screw terminals, you must insert the compression gland nut and the appropriate seal for
your configuration.
3 types of seals are supplied with the SIGFOX SENSORS: for a 5 mm diameter cable, for a 3 mm diameter cable, for 2 x 2.2 mm cables.
Assembly procedure:
1- Your sensor and its
2 - Pass the cable
analog interface.
through the compres-
sion gland nut.
Name
EE80
CO2, temperature, relative humidity
E+E Electronik
PR791F
Asco Instrument
PF211
Mitchell instruments
ADT 23-110
MSR Electronic
Luminosity, movements and motions
RBWF-LF
S+S Regeltechnik
Seal for 1 x 5 mm cable
Seal for 1 x 3 mm cable
3 - Pass the cable
through the compres-
107
sion gland seal
Type
Pressure
Relative humidity
Nitrogen dioxide NO2
Seal for 2 x 2.2 mm cables
90
4 - Pass the cable
through the SIGFOX
SENSORS'S case plate.
Applications
Buildings technical management, air quality,
ventilation, etc...
Industrial processes, static and dynamic
measurements, etc...
Heating, ventilation and air conditioning and
regulating ambient conditions...
NO2 detection in underground garages,
tunnels, shelters, industrial zones, etc...
Building technical management, motion
detection for management of lighting, venti-
lation, etc...
27
5 - Install the O-ring
6 - Connect the ends
seal on the case plate.
of the meter cable to
the screw terminals.
Page
31
of 41
Publicité
Table des Matières
