Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SIGFOX SENSORS - Mode d'emploi / User guide version V1.3
To optimise fixing to a tube or mast, we recommend removing the
DIN-Rail locking/unlocking lever.
To remove it, pull down on the lever until the locking lugs are clear,
then remove the lever.
2.8.2 Fixing with screws
The SIGFOX SENSORS is supplied with 2 CBLZ 2.2 x 19mm screws and 2 SX4 plugs. Use these or equivalent products to fix your product to a
flat surface.
You have a choice of two positions: flat or on its edge.
•
The edge position lets you distance the product from its support and therefore plays a part in better propagation of radio waves.
•
If you opt for the flat position, make sure you remove the DIN-Rail locking/unlocking lever as explained above.
49,50
Flat mounting
Screw holes for flat fixing
Screw holes for edge fixing
49,50
Edge mounting
Lugs
Clear part
49,50
Page
38
of 41
Publicité
Table des Matières
