Special Accessory Installation - GO2 Rangierhilfe RH 1 Mode D'emploi Et Instructions De Montage

5. For attachment in front of the axle on the AL-KO chassis M
with adjustable beams
In order to compensate for overlapping frame edges, the
AL-KO Chassis M adapter set (up to 1800 kg) must be used.
6. For attachment in front of the axle on the AL-KO chassis M
with continuous frame
In order to compensate for overlapping frame edges, the AL-KO
Chassis M adapter set (1900 kg to 2000 kg) must be used.
7. Installation on the Eriba Touring chassis
It is essential to use the Eriba Touring mounting set for the
Eriba Touring chassis.
8. Installation on chassis with L-profile and with a limited
amount of space
The short mounting system is required to compensate for the
height (30 or 60 mm) with substructures such as tanks.

Special accessory installation

1. Set of bolts
For height compensation with spacer plates, max. 45 mm
8 bolts conforming to DIN 933, M10 x 95 8.8, galvanized
Figure 7
2. Spacer plate kit
(Two 15 mm spacer plates)
For compensating for heights of up to 45 mm (3 plates) on
each side (e.g. installation behind the axle).
Figure 8
3. Low chassis kit
For height compensation for caravan / trailer with a frame height
less than 110 mm and / or bridging the struts.
Figure 9
If this installation kit is used in Germany, acceptance
by a vehicle expert is required
.
4. Low chassis kit, short
For height compensation for caravan / trailer with a frame height
less than 110 mm.
18
RH 1 Manoeuvring Assistant
Figure 10
If this installation kit is used in Germany, acceptance by
a vehicle expert is required
.
5. AL-KO Vario III / AV installation kit
Essential for caravans with AL-KO Vario III / AV Chassis
(frame thickness less than or = 2.8 mm).
Figure 11
6. Spacer place kit for single-axle caravans with a gross
weight of up to 1700 kg with AL-KO Vario III / AV Chassis
(2 x 4 15 mm spacer plates) for compensating for heights of up
to 60 mm.
Figure 12
7. AL-KO Chassis M
Adapter kit for chassis with an offset axle and a permitted gross
weight of up to 1800 kg. Mounting set for compensating for
frame edges for caravans with AL-KO chassis M. The mounting
set is needed for mounting in front of the axle.
Figure 13
8. AL-KO chassis M adapter set for chassis with a con-
tinuous frame and a permitted gross weight of 1900 kg to
2000 kg
Mounting set for compensating for frame edges for caravans
with AL-KO chassis M. The mounting set is needed for mount-
ing in front of the axle.
Figure 14