Troubleshooting - Parkside Pbv 4200 A1 Instructions De Fonctionnement Et De Sécurité

16. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work properly. If you can-
not localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause
Motor does not start • Safety switch bar not pressed
• Spark plug is defective
• Fuel tank is empty
• Fuel valve closed
Motor power diminishes • Ground too hard
• Cutting roller heavily worn
• Cutting roller worn out
Improper scarifying
• Incorrect scarifying depth
Motor runs, cutting roller • Toothed belt torn
does not rotate
14 GB/IE/NI/CY/MT
Remedy
• Press safety switch bar
• Replace spark plug
• Refill with fuel
• Set the fuel valve to ON
• Correct scarifying depth
• Have cutting roller replaced by a customer service work-
shop.
• Have cutting roller replaced by a customer service work-
shop.
• Correct scarifying depth
• Have toothed belt replaced by a customer service work-
shop.