Medela Pump In Style Pro+ Mode D'emploi page 7

PUTTING TOGETHER YOUR BREAST PUMP KIT
NOTICE
• To prevent damage to the breast pump all components must be completely dry before use.
1. Wash hands thoroughly.
2. Carefully insert the (dark yellow)
membrane with the flap into the opening
of the connector.
Æ Make sure that the membrane forms a
seal around the edge of the connector.
3. Close the lid of the connector until you
hear a click.
4. Screw the connector onto the bottle.
5. Carefully push the breast shield into the
connector body.
Æ Choose a breast shield size that suits
your needs. For proper sizing see
medela.com/fittingguide
6. The oval breast shields can be rotated
(360°) and placed in the desired position
to have the most comfortable fit for you.
7. Insert one of the short ends of the tubing
into the opening of the connector lid.
8. Insert the long end of the tubing into the
breast pump as far as it will go.
How to single pump
1. Insert the unused tubing end into the
tubing holder.
Æ Correctly assembled system (for single
pumping).
How to double pump
1. Assemble the second breast pump kit.
Æ Correctly assembled system (for double
pumping).
CAUTION
• If the battery light is yellow, charge the battery if you need to
pump for greater than 40 minutes away from a power source.
Can lead to material damage.
Tubing Features
Short ends of tubing
(connect to one or
two connectors)
Long end of tubing
(connects to breast pump)
Breast Pump Controls
Let-down button
(switches between Stimulation
and Expression Phases)
Decrease vacuum
button
Connects to long
end of tubing
Battery Status Indicators
• When the pump is charging (plugged into power source), the
battery status indicator will blink slowly; when the battery is fully
charged, the battery status indicator will be solid green.
• Color indicates remaining battery charge; see table below.
Battery Indicators
At least 60 minutes of pumping left
green
yellow At least 40 minutes of pumping left
Low battery, complete current pumping session; before starting a
red
new session, charge the battery or plug into a power source
WARNING
• If the battery light is red, complete current pumping
session; before starting a new session, charge the
battery or plug into a power source.
7
Tubing holder
(use for single pumping)
Connects to
power supply
Increase vacuum
button
On/Off button
Pumping phase
indicator
Vacuum level indicators
(bottom - level 1,
top - level 16)