Stryker Intouch Critical Care Bed Mode D'emploi page 97

A
B
F F i i g g u u r r e e 1 1 2 2 4 4 – – U U p p r r i i g g h h t t o o x x y y g g e e n n b b o o t t t t l l e e h h o o l l d d e e r r
A A t t t t a a c c h h i i n n g g t t h h e e r r i i g g h h t t f f i i t t o o x x y y g g e e n n b b o o t t t t l l e e h h o o l l d d e e r r o o p p t t i i o o n n
W W A A R R N N I I N N G G - - Always adjust the scale or bed exit system if you add an option while the scale or bed exit system is armed.
The right fit oxygen bottle holder option supports an oxygen bottle in a horizontal position on top of the headboard.
To attach the right fit oxygen bottle holder option:
1. Place the oxygen bottle holder on top of the headboard (A) (Figure 125).
2. Screw the oxygen bottle holder clasp onto the headboard (B) to secure the bottle holder to the product.
3. Route the bottom straps (C) through the headboard handles.
4. Attach the bottom straps to their respective fasteners.
5. Insert the oxygen bottle into the bottle holder.
6. Place the oxygen bottle holder cover on top of the oxygen bottle (D).
N N o o t t e e - - You can orient the oxygen bottle holder cover opening to face the right or left side of the product.
7. Fasten the oxygen bottle holder cover straps together (E).
2141-409-007 Rev AA.0 93 EN