Stryker Intouch Critical Care Bed Mode D'emploi page 50

S S e e t t t t i i n n g g t t h h e e a a l l a a r r m m t t o o n n e e s s
I I n n T T o o u u c c h h has 10 alarm tone settings.
N N o o t t e e - - If I I n n T T o o u u c c h h is equipped with the i Audio feature option, voice alarms are available. Voice alarms replace the buzzer
alarm and play through the inside siderail speakers.
N N a a m m e e
A Volume down
Volume up
B
Change tone
C
Change tone
D
E Test
C C o o n n n n e e c c t t i i n n g g a a s s u u p p p p o o r r t t s s u u r r f f a a c c e e t t o o I I n n T T o o u u c c h h
W W A A R R N N I I N N G G
• Do not use extension cords with support surfaces. Support surfaces are only intended to be powered by I I n n T T o o u u c c h h with
the supplied power cord.
• Do not route cables between the support surface and I I n n T T o o u u c c h h .
1. Install the support surface onto I I n n T T o o u u c c h h .
N N o o t t e e - - To install a support surface option onto I I n n T T o o u u c c h h , see the installation procedures in the appropriate support
surface operations manual.
2. Connect the integration cable from the support surface to the auxiliary mattress connector (B) (Figure 40).
3. Plug the support surface power cord into the auxiliary mattress connector outlet (A).
EN 46
Alarm settings
Volume
A
C
Tone 1
Test
F F i i g g u u r r e e 3 3 9 9 – – A A l l a a r r m m s s e e t t t t i i n n g g s s
F F u u n n c c t t i i o o n n
Decreases the volume
Increases the volume
Scrolls to the next tone
Scrolls to the previous tone
Tests the selected volume and tone setting
B
D
E
Close
2141-409-007 Rev AA.0