Stryker Intouch Critical Care Bed Mode D'emploi page 96

To operate the monitor tray option:
1. Pull down the tray support pole lock (G) (Figure 121).
2. Swing the tray support pole out 90° (H) (Figure 122).
3. Grasp the bottom of the monitor tray and flip it up onto the tray support pole (I) (Figure 123).
4. Press the monitor tray into the tray support pole to secure the monitor tray.
5. Using the strap, strap the monitor to the monitor tray.
F F i i g g u u r r e e 1 1 2 2 2 2 – – S S w w i i n n g g i i n n g g o o u u t t t t h h e e t t r r a a y y s s u u p p p p o o r r t t p p o o l l e e
F F i i g g u u r r e e 1 1 2 2 1 1 – – T T r r a a y y s s u u p p p p o o r r t t l l o o c c k k
F F i i g g u u r r e e 1 1 2 2 3 3 – – F F l l i i p p p p i i n n g g u u p p t t h h e e m m o o n n i i t t o o r r t t r r a a y y
A A t t t t a a c c h h i i n n g g t t h h e e u u p p r r i i g g h h t t o o x x y y g g e e n n b b o o t t t t l l e e h h o o l l d d e e r r o o p p t t i i o o n n
W W A A R R N N I I N N G G - - Always adjust the scale or bed exit system if you add an option while the scale or bed exit system is armed.
The upright oxygen bottle holder option supports an oxygen bottle in a vertical position.
To attach the upright oxygen bottle holder option:
1. Insert the support bar into the socket at the head end or foot end of the product on either side (A) (Figure 124).
N N o o t t e e - - Foot end functionality stops when you insert equipment into the sockets at the foot end of the product.
2. Insert the security chain pin (B) through the support bar hole to secure the bottle holder to the product.
EN 92 2141-409-007 Rev AA.0