Stryker Intouch Critical Care Bed Mode D'emploi page 53

P P o o s s i i t t i i o o n n i i n n g g a a p p a a t t i i e e n n t t o o n n t t h h e e s s u u p p p p o o r r t t s s u u r r f f a a c c e e
W W A A R R N N I I N N G G
• Always center the patient on the support surface. Align the patient's head toward the headboard before starting
functions. Check the patient frequently to make sure that you maintain the proper positioning.
• Always make sure that the tubing and wiring that is connected to the patient is long enough, stable, and secure during
Lateral Rotation or Turn Assist.
• Always raise all of the bed siderails before you begin Turn Assist or Lateral Rotation.
• Do not exceed the safe working load of the I I s s o o l l i i b b r r i i u u m m support surface. Excess weight could cause unpredictable safety
and performance of this system.
• Always use extra caution when reading radiology images taken of a patient on a support surface because internal
components can cause artifacts and distort readings.
C C A A U U T T I I O O N N
• Do not allow sharp objects to come into contact with the support surface that could puncture, tear, or cut the cover.
• Do not allow sharp edges from the X-ray plate to come in contact with the support surface cover. The recommendation is
you cover the X-ray plate with a pillow case or other device before placement under the patient. If damaged, remove the
support surface cover from service immediately to prevent cross contamination.
2141-409-007 Rev AA.0
F F i i g g u u r r e e 4 4 5 5 – – I I n n T T o o u u c c h h N N e e w w P P a a t t i i e e n n t t s s c c r r e e e e n n
49 EN