DeWalt DCMPH566N Traduction De La Notice D'instructions Originale page 37

Joining Trimmer Head Module to Handle
Module (Fig. A, C)
Combining the handle module
module creates a pole trimmer that is approximately
21
2.1 m long.
1. Align the groove on the outside of the coupling end of the
handle module 15 with the tongue on the inside of the
coupling end of the trimmer head module
2. Slide the threaded sleeve
down as far as possible and rotate the sleeve clockwise until
it stops and completely covers the threads.

WARNING: Always check to make sure that the sleeve is
completely threaded on and that the threads are no longer
visible. Not threading the sleeve completely on could
result in the modules becoming disconnected creating a
hazardous condition. Periodically check the connections
to insure that no threads are visible.
Pivoting the Trimmer Head (Fig. E–G)
The trimmer head pivots 180° and can be locked into seven
different positions within that range. To avoid being pinched,
do not grab the blades. Wear gloves and hold unit as shown in
Fig. G.

WARNING: Before connecting the battery to the unit, be
sure the trimmer head is locked into position.
To pivot the trimmer head
1. With one hand firmly gripping the trimmer head, use the
other hand to press the lock off button
trimmer head handle
14
2. Lock the trimmer head into one of the seven operating
positions as shown in Fig. F. To lock the trimmer head into
place, release your grip on the trimmer head handle
Check to make sure that trimmer head is locked into
position by trying to move the motor housing. If it is not
locked, rotate it to the nearest lock position.
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can cause injury.
Proper Hand Position (Fig. G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
and one hand on the auxiliary handle
to the trimmer head
15
21 .
8 on the trimmer head module
13 and rotate the
to pivot the trimmer head.
14
4 .
Instructions for Use

WARNING: Always observe the safety instructions and
applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can cause injury.
Switching Pole Hedge Trimmer On and Off
(Fig. A)
Ensure the trimmer head is locked into one of the seven
operating positions. Refer To Pivoting the Trimmer
Head section.
To turn the unit ON, squeeze the lock-off lever
On/Off trigger .
1
To turn the unit OFF, release the On/Off trigger and the lock-
off lever.

WARNING: Never attempt to lock the trigger in the
ON position.
Before Operating Pole Hedge Trimmer

WARNING: The unit has not been designed to provide
protection from electric shock in the event of contact with
overhead electric lines, Consult local regulations for safe
distances from overhead electric power lines and ensure
that the operating position is safe and secure before
operating the extended reach hedge trimmer.
• For safe operation, read and understand all instructions
before using the pole hedge trimmer. Follow all safety
instructions. Failure to follow all safety instructions listed
.
below, can result in serious personal injury.
• Watch what you are doing. Use common sense. Do not
operate pole hedge trimmer when you are tired.
• Only well-instructed adults should operate pole hedge
trimmer. Never allow children to operate.
• Do not use unit for any job except that for which it
is intended.
• Do not allow children or untrained individuals to use
this unit.
• Always use an approved hard hat when operating the
pole hedge trimmer overhead. Falling debris can result in
serious injury.
• Wear the following safety gear when operating pole hedge
trimmer:
head protection
‑
‑ heavy-duty gloves
‑ substantial footwear
‑ safety glasses, goggles or face screen
‑ face or dust mask (if working in dusty areas)
• Do not wear loose fitting clothing, or jewelry of any kind
that could get caught in the moving blades or parts of the
3
pole hedge trimmer.
EnGLIsH
and then the
2
35