The Refrigerator - GE 23 Série Manuel D'utilisation Et D'installation

INSTALLING THE REFRIGERATOR
PUT THE REFRIGERATOR
4
IN PLACE
Move the refrigerator to its final location.
LEVEL THE REFRIGERATOR
5
The refrigerator can be leveled by
adjusting the rollers located near the
bottom hinges.
Rollers have three purposes:
• Rollers adjust so the door closes easily
when opened about halfway. (Raise the
front about 5/8" [16 mm] from the floor.)
• Rollers adjust so the refrigerator is
firmly positioned on the floor and does
not wobble.
• Rollers allow you to move the
refrigerator away from the wall for
cleaning.
To adjust the rollers on 23' (33" wide),
25', 26', 27' and 29' models:
• Turn the roller
adjusting screws
clockwise to
raise the
refrigerator,
counterclockwise
to lower it. Use
a 3/8" hex socket
or wrench, or
an adjustable
wrench.
Installation Instructions
Raise
Rollers
Roller adjusting screw
(CONT.)
LEVEL THE REFRIGERATOR
5
(cont.)
To adjust the
rollers on 23
'/
CustomStyle ™
models:
Turn the front roller
adjusting screws
clockwise to raise

the refrigerator,

counterclockwise
to lower it. Use a 3/8" hex wrench with
extension, or an adjustable wrench.
These models also have rear adjustable
rollers so you can align the refrigerator
with your kitchen cabinets. Use a 3/8" hex
wrench with extension to turn the screws
for the rear rollers—clockwise to raise the
refrigerator, counterclockwise to lower it.
LEVEL THE DOORS
6
Adjust the refrigerator door to make the
doors even at the top.
To align:
A Using a 7/16" wrench, turn the door
adjusting screw to the right to raise the
door, to the left to lower it.
NOTE:
A nylon plug, imbedded in the threads
of the pin, prevents the pin from turning
unless a wrench is used.
B After one or two turns of the wrench,
open and close the refrigerator door and
check the alignment at the top of the doors.
28
25
'
Roller adjusting screws
Doors should be even at top
Raise
7/16" wrench