Wall Installation - CARVIN Gold Série Manuel Du Propriétaire

3. WALL INSTALLATION

WARNING
Do not install the wall on a windy day. Wait for a calm windless day.
You must be at least 3 people to install the wall.
3.1 Before starting the installation of the wall, make sure you
have the following items in the circle of your pool (inside the
rails) : two plywood sheets to support the wall, some sand to
make a cove or prefabricated cove sections and a stepladder
to be able to get out once the wall is up and installed.
3.2 Note that the skimmer hole and return are located at the
starting end of the rolled metal wall, therefore position the
roll to begin the unfolding of the wall of your pool where you
want to position these items.
3.3 Place the two plywood sheets inside the circle of the pool
close to where you intend to put the lter and pump. Take
out the wall from the box and place it on a plywood sheet.
3.4 Start unrolling the wall by guiding the bottom of the wall
into the lower slot of the rail (already positioned). The rst
end of the wall must be in the center of a bottom plate to
allow the installation of the screws so that they are hidden Water return
Skimmer
outlet
behind an upright.
ATTENTION: Be careful not to push any sand on or inside the
rails which would make it di cult to insert the wall into it.
3.5 We suggest you install the top rails gradually as the wall
is unrolled to give more stability to the metal sheet. It is also
recommended to hold and support the top of the wall until it
is fully installed, with the help of several people or by using
the vinyl covered hooks, rope and tent peg attached to the
top of the wall to make it stand as straight as possible.
47.