CARVIN Gold Série Manuel Du Propriétaire page 53

4. LINER INSTALLATION
(continued)
4.6 FASTENING THE LINER ON TO THE POOL WALL
For assembly with a
U/J type pool liner
4.6.1 The top of the liner has a welded vinyl ange to
hang the liner. It is called an overlap. Open it with your
Top rail
ngers and hang on the top of the wall.
4.6.2 Hang the liner on the wall all around the pool. The
Liner
liner should be free of any wrinkles or creases on the
vertical portion on the walls. If this is the case, adjust the
liner by turning the bottom of the liner, or by adjusting the
Pool wall
overlap on the wall contour.
4.6.3 As you install and hang the overlap liner, assemble
the top rails to solidify the pool. Position these top rails to
be aligned with the bottom rails because the uprights will
have to be installed in top and bottom plates which are
the junction between rails.
You might need a rubber mallet to place the upper rails in
position and properly lock the liner in place.
Do not cut the excess liner on the outside of the wall of
the pool. If disassembly or reassembly is necessary, a
liner that has been cut will be much more di cult to
position. If the excess liner is too long, simply fold it and
fasten it with tape.
51.