CARVIN Gold Série Manuel Du Propriétaire page 56

5. STRUCTURE ASSEMBLY
(continued)
5.4.3 Hold the rear part of the top ledge cover against top
ledge (interior of the pool) and push on the front part
(exterior of the pool) of the top ledge cover so that the
shape of the top ledge cover is pressed and ush with top
ledge.
5.4.4 Line up the center slot of top ledge cover with the
center hole of top plate. Screw together using screw
14455032.
5.4.5 Install the top ledge cover cap by pushing it into
place until it clicks.
Screws on the bottom of the uprights can now be
installed to solidify the whole structure and prevent
uprights and bottom plates against ground movements
due to freezing / thawing.
54.