General Maintenance - CARVIN Gold Série Manuel Du Propriétaire

The parts most likely to cause a leakage problem are the skimmer and the water return. Regularly inspect the areas
of these two components to make sure there is no water leakage on the wall of the pool. Make the necessary
repairs to the protection joints of the skimmer and water return (see replacement of these parts) to stop any
leakage as it may cause rust and seriously damage the pool wall, the bursting of the pool that could cause
NEGLECTING THESE INSPECTIONS AND REPAIRS WILL VOID THE WARRANTY OF THE POOL.
Your pool liner must be inspected regularly for leaks. Also, inspect your wall for corrosion and scratches. If problems
are detected, ACTION MUST BE TAKEN IMMEDIATELY. Small leaks or holes in the liner can be repaired easily using
repair kits sold at your dealer. Corrosion and scratches on the pool wall must be repaired by using an anti-rust
enameling product. Rub the rusted surface with a wire brush, apply the anti-rust product and repaint the wall to
match the repair to the color of the wall.
The pool water contains several corrosive products for the wall of the pool. It is important to check that there are no
leaks in the liner. Any leaks will cause corrosion to the pool wall which, if not treated quickly, will reduce the strength
of the wall. The wall could collapse and cause signi cant damage to your property and/or your neighbors and could
also cause major injuries to people near or in the pool.
Keep the wall and resin structure clean. Always clean chemical deposits that may appear on exterior surfaces of the
pool. Cleaning the surfaces of the pool, structure and wall, is recommended at least once a year with a cleaning
product without bleach.
Parameter
Temperature Range
Salt Concentration
Cyanuric Acid
pH
Free Chlorine
Combined Chlorine (Chloramine)
Total Alkalinity
Calcium Hardness
Total Dissolved Solids (TDS)
Including Salt
Metals (Copper, Iron, Manganese)
Nitrate
Phosphate
Saturation Index
ppm = part-per-million, ppb = part per billion

7. GENERAL MAINTENANCE

signi cant damage to your property and/or your neighbors.
TABLE - RECOMMENDED WATER CHEMICAL PARAMETERS
IMPORTANT NOTE
NEGLECTING MAINTENANCE OF YOUR POOL WILL
VOID THE WARRANTY OF YOUR POOL.
Minimum Target
+50˚F
-
(+10˚C)
3000 ppm 3300 ppm
30 ppm 80 ppm
7.2 -
1.0 ppm -
- 0 ppm
80 ppm -
200 ppm -
- -
- None
- None
0.0
-0.2
Maximum
+122˚F
(+50˚C)
4000 ppm
100 ppm
7.8
3.0 ppm
-
120 ppm
300 ppm
6000 ppm
-
-
125 ppb
+0.2
57.