CARVIN Gold Série Manuel Du Propriétaire page 52

4. LINER INSTALLATION
The liner dimensions are usually smaller than those of the
pool frame. It is recommended to spread the liner in the
sun for an hour or two before starting the installation so
that the liner can warm up. It will stretch better under
these conditions and facilitate the installation.
SELECT A LINER THAT MEETS APSP-4
LINER PERFORMANCE REQUIREMENTS.
DO NOT ATTEMP TO INSTALL THE LINER ON A COLD DAY
WITHOUT SUN. AVOID TO FILL THE SWIMMING POOL WITH
VERY COLD WATER.
4.1 Open the liner box.
IMPORTANT : DO NOT USE SHARP
TOOLS TO OPEN THE BOX
4.2 Take out and unfold the liner from the box and spread
out in the sun so it can warm up and stretch.
4.3 Inspect the liner, the seams and the complete surface
to make sure there are no holes.
It is better to remove your shoes to
Design pattern up
prevent damaging the bottom of the liner.
4.4 Spread the liner inside the pool with design pattern up.
The seam at the bottom of the liner should be placed in the
center of the basin. All other seams must form parallel
straight lines.
4.5 Make sure liner is free of wrinkles at the bottom of the
pool.
50.