CARVIN Gold Série Manuel Du Propriétaire page 54

5. STRUCTURE ASSEMBLY
5.1 UPRIGHT INSTALLATION
Before starting the installation of the uprights, check if
the bottom plates are centered correctly into the rails of
each plate. Adjust if necessary.
5.1.1 Insert uprights into each bottom plates. Push the
upright down until you hear a click.
5.1.2 Holes are located on each side of each bottom plate
to install screws. The installation of these screws is
mandatory to make the assembly even more solid against
ground movements due to freeze / thaw.
Do not install these screws for now. Wait until the top
seats are positioned in place to install the screws.
5.2 TOP PLATE INSTALLATION
5.2.1Tilt the top plate so that the inside part hooks onto
the top rail. Then, lower the top plate to press down
against the upright.
5.2.2 Make sure the holes on top plates are aligned with
the holes on top of uprights. Install the 4 auto tapping
screws (14455032) to assemble the top plates on the
uprights.
52.