CARVIN Gold Série Manuel Du Propriétaire page 50

3. WALL INSTALLATION
(continued)
3.6 BASIN ASSEMBLY
Once the wall is completely unrolled and inserted into the
bottom rails, you could be faced with 3 situations:
- The wall seems too long (it is not)
See Step 3.6.1
- The wall seems too short (it is not)
See Step 3.6.2
- The assembly holes at both ends of the wall are perfectly
aligned
Go to Step 3.7
3.6.1 If your wall seems too long, the spaces between the
rails in the bottom plates should be enlarged. Gently tap
each rail inside of the bottom plate outwards so that the
circumference is slightly enlarged.
3.6.2 If your wall seems too short, the spaces between the
rails in the bottom plates should be reduced. Gently tap
each rail inside of the bottom plate towards the inside so
that the circumference is slightly reduced.
If you have done one of the two steps (3.6.1 or 3.6.2) you
absolutely have to recheck the spacing between the rails
in each bottom plate to make sure that spacing is equal in
all plates.
IMPORTANT! Screw heads must
be inside the pool
3.7 When the assembly holes of the wall are aligned, you
IMPORTANT! Use a torque wrench of
will be able to join them together. To do this, place both
8.5Nm (75 in.pd)
ends of the wall on top of each other then place the two
steel bars, one inside, the other outside the wall. To help
Exterior
you align the holes of steel bars to wall, insert two or three
punch or screwdrivers into holes to keep joint aligned.
Then, insert screws and nuts provided for the wall (screw
heads inside the pool and nuts outside); do not tighten
them for now.
Interior
Make sure all holes have screws and nuts. Once all screws
and nuts are in place, tighten them.
Tighten all the screws without forgetting any, because this
could cause an alignment problem.
48.