Filling The Pool With Water - CARVIN Gold Série Manuel Du Propriétaire

6. FILLING THE POOL WITH WATER

6.1 You can use a vacuum cleaner to remove the air
between the liner and the pool wall. By removing the air,
the liner will stretch a little and start sticking to the pool
wall. This will allow you to correct the surface of the liner
and remove folds and wrinkles.
ATTENTION :
- Do not use an industrial vacuum cleaner that could suck
the liner and damage it or pierce it.
- Make sure the vacuum cleaner nozzle does not have
sharp corner(s) that could damage the liner. Tape the end
of the nozzle to prevent any damage.
- Insert the end of the nozzle into the return of the wall
(about 12 in./30cm). Make sure the nozzle is at least 4
in./10cm from the cove of the pool so it is not moved or
sucked by the vacuum cleaner.
- Tape the vacuum hose to the side of the pool wall with
"Duct tape". Make sure the return hole is blocked properly
to keep air out. The vacuum must be outside the pool.
6.2 Close skimmer opening on the outside of the pool wall
with cardboard and duct tape to also prevent air from
escaping.
6.3 Start the vacuum cleaner. The liner will begin to stick
against the wall. If you notice any wrinkles, smooth out
the bottom. To avoid damaging the liner do not wear
shoes for this step.
6.4 Start lling the pool with water. Keep checking for
wrinkles. Smooth out any visible wrinkles before there is
too much water in the pool preventing the liner from
moving.
Duct Tape
Water
return
outlet
Skimmer
Duct Tape
Water
return
outlet
Skimmer
55.