CARVIN Gold Série Manuel Du Propriétaire page 58

6. FILLING THE POOL WITH WATER
6.5 When you reach 4-5" (10-15 cm) of water in the pool,
turn o the vacuum and remove the hose.
6.6 Continue lling the pool until the water level is about
2" (5 cm) under the water return hole.
Before cutting the liner hole for the water return or the
skimmer opening, wait until there is at least 24" (60 cm)
of water in the pool for the liner to have stretched
Fill the pool with at least 12" (30 cm) of water with a
gardening water hose to allow the liner to stretch and
give you time to put it back in place if you see any
wrinkles. Afterwards, you will be able to use a more
powerful water supply.
6.7 Stop lling with water and install the water return
inlet and skimmer by following the installation
instructions for these features.
A basic circulation and ltration system
MUST BE INSTALLED.
This system includes the following products by
installation order:
- A skimmer
- Pool pump
- Filter
- Water return
Install the safety stickers provided with your pool as
listed in the "warnings" on page 36 of this manual
Make sure you follow all local and provincial regulations when you proceed with pool accessories installation.
The components allowing entry into the pool must be approved for the safety of users.
properly.
IMPORTANT NOTE
(suite)
Skimmer
Water return
outlet
Remove the hose
4''
Skimmer
Water return
outlet
2''
56.