Setting A Programme; Changing The Programme; Automatic Programmes - CONSTRUCTA CC4W91860 Notice D'utilisation

PAutomatic programmes
Y ou can prepare food really easily using the automatic
A u t o m a t i c p r o g r a m m e s
programmes. You select the programme and enter the
weight of your food. The automatic programme then
applies the most suitable settings. You can select from
15 programmes.
Notes
Take the food out of its packaging and weigh it. If it
■
is not possible to enter the exact weight, you should
round it up or down.
Place the food in the cold cooking compartment.
■
For the programmes, always use microwaveable,
■
heat-resistant cookware, for example made of glass
or ceramic. Observe the accessories tips in the
programme table.
For an optimal cooking result, use food that is in
■
good condition and chilled meat only. For frozen
food, use food straight out of the freezer only.

Setting a programme

Example in the picture: Programme 3 with a weight of 1
kg.
Touch the = button.
1.
The first programme number and default weight and
cooking time will be shown on the display.
Select programme number 3 using the settings area.
2.
Touch the °C/A button.
3.
The weight setting will be highlighted on the display.
Set the weight to 1 kg using the settings area.
4.
The appliance automatically sets the right cooking
time for that weight.
Touch the IH button.
5.
The programme will start. The cooking time will count
down on the display and the temperature bar and
LED IH will be lit.
Note: Once you have started the programme, the
programme number and weight cannot be changed.
The programme has finished
An audible signal sounds. The programme has finished;
the appliance stops heating.
Touch #.
Note: You can use the settings area to extend or set a
new cooking time.

Changing the programme

Touch the IH field for approx. four seconds.
1.
The programme is reset.
Select a new programme.
2.
Pausing the operation
Touch the IH field or open the appliance door.
1.
The operation is suspended and the IH LED flashes.
Close the appliance door.
2.
Touch the IH field.
3.
The operation is continued and the IH LED lights up.
Cancelling operation
Touch #.
The appliance will stop heating and all the settings will
be cleared.
Note: The fan may continue to run after the appliance
has been paused or stopped.

Automatic programmes

en
49