Accessories; Accessories Included; Special Accessories; Before Using For The First Time - CONSTRUCTA CC4W91860 Notice D'utilisation

_Accessories

B elow, you will find an overview of the accessories
A c c e s s o r i e s
included and information on how to use them correctly.
Caution!
When removing dishes, make sure that the turntable
does not move. Make sure that the turntable is properly
locked. The turntable can turn left or right.

Accessories included

Special accessories

You can obtain further accessories from the after-sales
service or from specialist retailers.
Special accessories
Glass roasting dish
For pot roasts and bakes that you prepare in the oven.
Pizza tray
For pizzas and large round cakes.
Steamer for microwave appliances
For steaming food more quickly and more gently.
--------
Turntable
Food that requires a lot of heat
from below can be cooked
directly on the turntable.
Note: The turntable can turn
clockwise or anti-clockwise. It is
scratch-resistant. You can slice
pizza directly on the turntable.
Low wire rack
For the microwave and for
baking and roasting in the oven.
Note: Place the wire rack onto
the turntable.
Tall wire rack
Wire rack for grilling, e.g. steak,
sausages or bread, or for
setting down cookware, e.g.
shallow ovenproof dishes.
Note: Place the wire rack onto
the turntable.
KBefore using for the first
time
B efore you can use your new appliance, you must
B e f o r e u s i n g f o r t h e f i r s t t i m e
make some settings. You must also clean the cooking
compartment and accessories.
The appliance must be fully installed and connected to
the mains.

Fitting the turntable

As shown in the figure, place the turntable with rollers
"A" onto the turntable drive coupling "B" in the centre of
the cooking compartment floor.
Notes
Never use the appliance without the turntable
■
The turntable must sit straight on the turntable drive
■
coupling.
The turntable must turn, whichever heating function
■
is being used.
The maximum load for the turntable is 5 kg.
■

Initial use

After connecting the electricity supply or after a power
cut, the display prompts you to set the time. It may take
a few seconds for the instruction to appear.
Setting the time
During initial use, the time display is highlighted. ‚ƒ:‹‹
flashes on the display and the 0 symbol lights up. Set
the time.
Use the settings area to set the time.
1.
Touch 0.
2.
The time has now been set.
Changing the time
Touch 0 twice.
1.
The 0 symbol and the time appear on the display.
Use the settings area to set the time.
2.
Touch 0.
3.
The time has now been set.
Notes
If 0 is not touched after setting the time, the set
■
value is automatically adopted after a few seconds.
You can touch 0 at any time to change the time
■
setting.
In order to reduce the energy consumption of your
■
appliance in standby, you can hide the time.
Accessories
en
43